Install The Hardware - Axis T93G Series Installationsanleitung

Install the Hardware

NO TICE TICE
NO NO TICE
Be careful not to scratch, damage or leave fingerprints on the window because this could
decrease image quality.
The Axis product can be installed with the cables routed through or along the wall.
Read all the instructions before installing the product:
1. Install the wall mount. See page 9 . For detailed instructions, see the wall mount's
Installation Guide, supplied in the package or available on www.axis.com
2. Install the camera in the housing. See page 9 .
3. Attach the housing to the wall mount. See page 12.
Install the Wall Mount
CAUTION
Make sure that the screws and plugs are appropriate for the material (e.g. wood, metal,
drywall, stone) and that the material is strong enough to support the combined weight
of the camera, housing, and wall mount.
Note
• See also the wall mount's Installation Guide supplied in the package and available on
www.axis.com
• For technical specifications about the connectors, see the camera's User Manual available
on www.axis.com
1. Prepare the wall for installation of the wall mount. Use the wall bracket as a template
and mark the holes before drilling the holes.
2. Route the network cable and, if required, the power cable through the wall bracket.
Leave approximately 30 cm (11.8 in) of cable for connecting the camera.
3. If connecting an auxiliary device, for example an I/O, audio, or external power device, to
the camera, repeat the step above as applicable to the specific device.
4. Fasten the wall bracket to the wall by tightening the screws.
Install the Camera in the Housing
1. If connecting external/input devices to the camera, connect them according to the
instructions in the camera's Installation Guide before attaching the camera to the holder.
2. If using a microSD card for local storage, insert the card into the camera's SD card slot.
3. Loosen the holder screws and remove the holder from the housing.
AXIS T93G Series
9