G&D DL-DVI-Vision-Fiber Serie Installation Und Bedienung Seite 78

Installation
USB 2.0 Trans.|Tx:
cable connected to the USB 2.0 Trans.|Rx interface of the computer module.
USB 2.0 Trans.|Rx:
cable connected to the USB 2.0 Trans.|Tx interface of the computer module.
Connecting an additional interface of the CON-2 variants
NOTE: With the also available
nect a console to two different digital extenders of the Vision series.
Alternatively, you can connect a compatible matrix switch to each of the two
channels instead of a digital extender.
Transmission 2
Transmission 1
IMPORTANT: The device uses components with laser technology which comply
with laser class 1.
Never stare directly into the beam when wearing optical instruments!
NOTE:
Remove the protection caps from the Transmission interfaces and the cable
plugs.
Transmission|Tx: Insert the LC plug of the fibre optic cable connected to the Transmis-
sion|Rx interface of a compatible computer module or matrix switch.
Transmission|Rx: Insert the LC plug of the fibre optic cable connected to the Transmis-
sion|Tx interface of a compatible computer module or matrix switch.
9 · G&D DL-DVI-Vision-Fiber
When using an
ARU2
When using an
ARU2
CON-2
Serial
USB 2.0 Devices
Micro In Speaker
DVI-D DL Out
variant, insert the LC plug of the fibre optic
variant, insert the LC plug of the fibre optic
versions of the user modules, you can con-
Mouse
Generic
Keyb./Mouse Keyb. Red. Power