Turning The Device On For The First Time; The Network Setup Wizard; Integration Via Cable - Imperial DABMAN i500 BT Bedienungsanleitung

8.0 Turning the device on for the first time

To operate the DABMAN i500 BT, press the on/off button on the remote control or on
the radio itself.
After turning on the device, you will be taken to the setup wizard, which will assist you in
setting up your DABMAN i500 BT radio.
Then set the format for the time (12/24-hour clock).
The next step is the date and time, which you set individually with the navigation wheel and
confirm by pressing the wheel or via the remote control. The date format used is Euro-
pean - the day comes first, followed by the month. Then you can choose a WLAN region. If
you're not based in Spain or France, „Most of Europe" is the right choice for a European.
E

The network setup wizard

Since the DABMAN i500 BT, as a network device, doesn't yet have any information about
the possible network environments from which it will obtain its contents, it automatically
accesses the network setup wizard after initial power-up and language selection:
As with all other DABMAN menus, you can navigate through the selection using the navi-
gation wheel or the „Up" and „Down" or „Left" and „Right" buttons on the remote control.
Confirm by pressing the navigation wheel or OK on the remote control.

Integration via cable

If a network cable is plugged in when the device is turned on and the connection to a
functioning network is established, the setup should be very quick and uncomplicated, as
follows:
If a DHCP server is active for your router - as in almost every current model, please select
„Cable".
The wizard now automatically connects to your router and obtains its network address
from the DHCP server. Any device wishing to participate in the network needs a „house
number" like this so that the data packets can be delivered properly.
In some rare cases, however, fixed IP addresses are distributed for certain access regu-
73 IMPERIAL DABMAN i500 BT