Unitec 77954 Gebrauchsanweisung Seite 9

The charging time of a battery depends on its size, its condition and its level of discharge.
This battery charger has a maximum charging current of 3.2 A. The charging current
gradually decreases. By the end of the charging process it even becomes very low
because of the charger's overcharge protection.
The charging process takes about 12 to 13 hours with a 40 Ah battery (3.2 A) or about
18 to 19 hours with a 60 Ah battery (3.2 A).
1. Pull the battery charger's mains plug out of the alternating current supply socket.
2. Disconnect the negative charging clip (black) from the car bodywork or from the
negative terminal of the battery.
3. Disconnect the positive charging clip (red) from the positive terminal of the battery.
Clean the device only when it is disconnected from the power supply, using a slightly
damp, soft cloth. Prevent liquids from penetrating the device.
At the end of its working life, do not dispose of this product in the domestic refuse
but at the points set up for the return of used electrical devices.
You can obtain more details from your public disposal authority.
Article no.:
Input voltage:
Charging current:
Output voltage:
Suitable batteries:
.
77954_Bed_A5_140317.indd 9
77954
220 - 240 V AC / 50-60 Hz
Maximum 3.2 A
Motorcycle:
1.2-14 Ah / 14.4 V DC – 0.9 A 1.2-14 Ah / 14.4 V DC – 0.9 A
Car:
14-120 Ah / 14.4 V DC – 3.2 A 14-120 Ah / 14.4 V DC – 3.2 A
Cold weather:
14-120 Ah / 14.7 V DC – 3.2 A
12 Volt lead acid batteries
(including low-maintenance and maintenance-free ones),
gel and AGM batteries
Charging time
of the battery
Ending the
charging process
Cleaning instructions
Disposal instructions
Technical data
24.03.14 09:47