kellermann Atto Anbauanleitung Seite 2

Installation Manual
Atto® / Atto® Dark / Rhombus S Dark
Atto® schwarz
Rhombus S Dark
Dear customer,
thank you for placing your trust in us by purchasing this pro-
duct. Please read these instructions carefully and completely
before deciding whether you would like to do the installation
yourself or have it done by a professional.
Legal note:
All Kellermann Atto® / Atto® Dark / Rhombus S Dark are ECE-approved
for motorcycles as documented by the approval mark engraved into
the housing or lens. This means that you may use the Kellermann
products instead of the original indicator lights without any entry
in your vehicle documents or presentation to a vehicle inspection
organization. You do not need to carry any documentation
with you. This applies to all motorbikes licensed under EU
law and the corresponding lights.
ATTENTION! The warranty will not apply if the turn signal has
not been correctly installed or connected to the electrical sup-
ply on your motorcycle. Do not carry out the installation unless
you are qualifi ed to do so; otherwise, leave the installation and
connection work for your indicator to a qualifi ed repair shop. The
warranty does not apply to damage due to wrong connection
or excess voltage (such as due to a defective alternator regulator).
ATTENTION! Improper mechanical installation or orientation of
the Atto®/Atto® Dark /Rhombus S Dark may invalidate your mo-
torcycle's roadworthiness and insurance protection, or even lead
to accidents. Before every usage of your vehicle, check whether
the Atto®/Atto® Dark/Rhombus S Dark are correctly mounted and
fully functional.
ATTENTION! Your Atto®/Atto® Dark/ Rhombus S Dark may heat
up during use. Contact with bare skin or heat-sensitive objects
may lead to damage or injury.
CLEANING ADVICE! Your new Kellermann products are pre-
mium-quality products. In order to enjoy them long time and
maintain the warranty we recommend not to use any cleansers
with alkaline/acid and/or grinding substances or steel wool. We
also advice not to use steam cleaners.
INSTALLATION
ATTENTION! Make sure that your motorcycle is standing fi rmly
before you start work, as a fall may lead to damage to the motorcycle
or injury to you or others.
Dismantle the original indicators. Mount the Atto®/Atto® Dark/
Rhombus S Dark in place of the original indicators, or drill an 5 mm
diameter hole and fasten the Atto®/Atto® Dark /Rhombus S Dark
at 5 Nm with the nut supplied. Use adapters, if necessary, availa-
ble at www.kellermann-online.com. Make sure that the area where
the wires emerge is protected from splash water. Mount the Atto®/
Atto® Dark /Rhombus S Dark in such a way that the beams run ho-
rizontally in your bike's direction of travel. Alignment is important
to safety in traffi c and essential to your bike's roadworthiness, as a
bike with incorrectly aligned lights is easy to overlook on the road.
Make sure that you keep the following measures in selecting
your fastening point:
Position · In width:
For front indicators: minimum distance of 240 mm
For rear indicators: minimum distance of 180 mm
Minimum distance between the illuminating surface of the indicators and the headlamp:
75 mm
In height:
350 mm -1200 mm above the ground
Atto® chrom Atto® Dark
In length:
The distance between the rear indicators and the rearmost limit
of vehicle´s over-all length shall not exceed 300 mm
Geometric visibility:
Horizontal angles: 20° inwards, 80° outwards
Vertical angles: 15° above and below the horizontal
ELECTRICAL CONNECTION
Cut the wires of the original indicators between the indicator and
the connector. By doing this the wiring loom stays untouched.
Connect the grey cable to „plus" and the black cable to „minus".
To connect the wires of the Atto®/Atto® Dark /Rhombus S Dark to
the wires of the original connector there are crimp connectors and
shrink tubings included in the delivery. First push one of the shrink-
on tubes over one of the cables you want to connect and re-
move five millimeter of insulation on the end of each cable. Then
push both bare ends into a crimp connector and crimp it with an
appropriate tool. Then pull the shrink-on tube over the connection
and heat it up equally until it fi ts tight over the complete length.
This type of connection is technically permanent. To create
a non-permanent connection, we recommend Posilock wire
connectors (not included), which are available for purchase from
our website at www.kellermann-online.com
123.956).
Lay the cables in a way, that they are protected from splash water
and fasten them, e.g. by using zip ties. Now test the function of the
Atto®/Atto® Dark /Rhombus S Dark.
This completes the installation.
INDICATOR FLASH RATE
The fl ashing frequency can change when converting the original
indicators. The installation of a load-independent fl asher relay (e.g.
R 2) or a multifunctional assistance system (e.g. CR 4®) will solve
the problem. If the installation is not possible or not favored, then
parallel connected power resistors (i.LOAD) will be an option. Only
a few vehicles need special solutions, which we offer as i.SED, i.BOS
products.
We are happy to answer any questions you may have with regards
to converting your indicators, we are certain we can help you.
Our team is constantly working on new, improved solutions for all
models and vehicles. If you are not sure which electronic equip-
ment you require, please contact us via
or call us: +49 (0)241/93 80 8-0.
com
ATTENTION! The application of the described measure may
interrupt correct functionality, in the case of a failure causing
one of the indicator lights to increase in fl ash frequency in
order to alert the driver of such a failure. Before each usage
of the vehicle, check the functionality of the indicator lights.
The Kellermann Atto®/Atto® Dark /Rhombus S Dark is equipped
with the tried-and-trusted Longlife Protection Guard® circuit,
which ensures extremely long life with LED technology. It is not
necessary to replace the illuminant and, due to the UNECE regula-
tions, it would not be allowed either.
Atto® Atto® Dark
www.kellermann-online.com
english
(Order No.: 123.955 /
www.kellermann-online.
Rhombus S Dark