Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INCIDENT
I have programmed the
pyrolysis function, the oven is
working properly but pilot light
is not lit up.
The pyrolysis programme has
ended and the oven is cold,
but the door is locked and
symbol
is flashing.
The control dial is in position
0 and the door is still locked.
The control dial is in position
0, the oven is cold and the
door is still locked.
I have put the control dial in
position 0 and the door is
unlocked, however symbol
is still lit up and the remaining
time of the cleaning cycle can
be seen on the
display.
CAUSE
Pilot light
does not work
properly.
You did not turn the control
dial to position 0 when the
pyrolysis programme ended.
The oven has not cooled down
to the safe temperature.
You have not followed the
instructions to cancel the
operation correctly.
You have not followed the
instructions to cancel the
operation correctly.
SOLUTION
Call the Technical Assistance
Service.
1. Turn the control dial to
position 0 and wait for 1
minute.
2. Turn the control dial to
position
and wait for 1
minute.
3. Turn the control dial to
position 0 again and wait
until pilot light
Wait until the oven cools and
pilot light
turns off.
1. Turn the control dial to
position 0 and wait for 1
minute.
2. Turn the control dial to
position
and wait for 1
minute.
3. Turn the control dial to
position 0 again and wait
until pilot light
off.
Follow the instructions to
cancel the pyrolysis
programme.
turns off.
turns
29
Werbung
