Location; Room Temperature; General Considerations - Red Sea S-500 Installation Und Betriebsanleitung

Location

The first step in setting up the MAX
Weight
The MAX ® S aquariums are supported by 9-12 adjustable feet (depending on model). The flooring directly
below the legs must be rated for a static loading of at least 15 kg / cm2 (220 lbs/square inch).

Room temperature

Site selection is important for correct temperature maintenance. We recommended that you keep the
ambient room temperature a comfortable and stable 22°C / 72°F. Avoid placing the tank in front of an air
conditioner, heating vents or direct sunlight. A well ventilated room with moderate light is the best place to
position the aquarium.
Accessibility
• Back: Ensure that there is at least 15cm / 6" of clearance behind the MAX
maintenance of the flow valve on the main downpipe as well as sufficient air circulation for a chiller.
• Sides – Rear: Ensure that there is sufficient room (approximately 60cm / 24") between both sides
of the aquarium and any adjacent walls or furniture for access to the rear of the tank. In addition to
the regular maintenance of the surface skimmer, pumps and return flow vents of the rear chamber,
specific access is required as follows: Left side - filling of Top-up water reservoir, installing/removing
cables to power drawer. Right side – adjustment and maintenance of down-flow valve.
• Sides – Front: Ensure that there is approximately the length of the tank free on at least one of the
sides. This is to enable the installation/replacement of the color trim on the tank as well as being able
to replace the tubes in the front and rear light units without having to remove it from the aquarium.

General considerations:

Ensure that the area surrounding the aquarium is waterproof and consider moving away anything that water
might damage or may be corroded by the salt.
NOTE: The MAX
S system should not be moved when full of water.
®
®
S is to choose a suitable location.
MAX S-Series LED Installation & Operation Manual's
®
® to allow for operation and
EN
5