Return And Disposal - WIKA CPB3800 Betriebsanleitung

8. Faults / 9. Return and disposal
Faults
Dead-weight tester
screw press becomes
very stiff to operate
when dead-weight
tester is being used
in range below
140 bar (2,000 lb/in²)
Dead-weight tester
screw press becomes
very stiff to operate
when dead-weight
tester is being used in
range above 140 bar
(2,000 lb/in²)
CAUTION!
If faults cannot be eliminated by means of the measures listed above,
the dead-weight tester must be shut down immediately, and it must be
ensured that pressure is no longer present, and it must be prevented
from being inadvertently put back into service.
In this case, contact the manufacturer.
If a return is needed, please follow the instructions given in chapter
9.1 "Return".

9. Return and disposal

WARNING!
Residual media at the dead-weight tester can result in a risk to persons,
the environment and equipment. Take sufficient precautionary measures.
9.1 Return
WARNING!
Strictly observe the following when shipping the instrument:
All instruments delivered to DH-Budenberg/WIKA must be free from any
kind of hazardous substances (acids, bases, solutions etc.).
WIKA operating instructions model CPB3800
Causes
Internal damage
Incorrect operating procedure
being used.
If unable to locate a cause.
Measures
Return dead-weight tester to DH-
Budenberg/WIKA for investigation.
Ensure that correct operating
procedure is being followed (see
chapter 6.6).
Return dead-weight tester to DH-
Budenberg/WIKA for investigation.
EN
43