Kensington PowerGuard with BungeeAir Kurzanleitung Seite 28

• If the battery inside the PowerGuard leaks for any reason, discontinue use, and
do not allow the PowerGuard's contents to contact your skin or eyes. In the
event of accidental contact wash the affected area with large amounts of water
and seek medical attention immediately.
• Your PowerGuard is not a toy. Keep it away from children. Insure that all persons
who use this product read and follow these warnings and instructions.
• Do not leave the PowerGuard on prolonged charge when not in use.
• Do not store your PowerGuard at elevated temperatures (such as in your car) or
in high humidity.
Disposing of your PowerGuard
• Do not incinerate or dispose of your PowerGuard in a fire or microwave.
• Do not dispose of your PowerGuard as ordinary refuse, as it contains lithium
based batteries. Consult your local municipal or civil authority for instructions
on correctly disposing of a lithium based battery.
• In the USA and Canada: This mark
recycled by the Rechargeable Battery Recovery Corporation ("RBRC"). When
you are ready to dispose of the PowerGuard, please contact the RBRC at
1-800-8-BATTERY or www.rbrc.org.
RF TECHNICAL SPECIFICATIONS
Single Channel – RF Frequency - 2.4395 – 2.4405 GHz
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment causes harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• R eorient or relocate the receiving antenna.
• I ncrease the separation between the equipment and receiver.
• C onnect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• C onsult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS: Modifications not expressly approved by Kensington may void the user's
authority to operate the device under FCC regulations and must not be made.
SHIELDED CABLES: In order to meet FCC requirements, all connections to equipment using a
Kensington input device should be made using only the shielded cables.
FCC DECLARATION OF CONFORMITY COMPLIANCE STATEMENT
This product complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation. As defined
in Section 2.909 of the FCC Rules, the responsible party for this device is Kensington Computer
Product Group, 333 Twin Dolphin Drive, Redwood Shores, CA 94065,USA.
indicates your PowerGuard can be
29