Transferring Recordings To A Computer; Resetting The Device; Changing The Fuse - Kompernass CR 5 A2 Bedienungsanleitung Und Sicherheitshinweise

Transferring recordings to a computer

Connect the mini-USB plug of the supplied USB cable
the camera and the USB plug to a free USB port of a switched-on computer . The
computer now recognises the device as "mass storage", the camera connects to the
computer and then the content of the SD/SDHC memory card appears as a new
drive on the computer . Now carry out the required file operations .

Resetting the device

If the device does not work as described in this manual or it does not respond to
your operation, use a pointed object, e .g . a paper clip, to carefully press the switch
behind the RESET opening

Changing the fuse

The car adapter
cause the fuse is defective . Exchange the defective fuse for a replacement fuse of the
same type (see also chapter Technical data) .
♦ To do this, pull the car adapter
♦ Open the car adapter
anticlockwise (using pliers if necessary) and removing it .
♦ Now, take the plug tip (B) from the fuse (A), remove the fuse (A) and place it to
one side .
♦ Now place the new fuse into the car adapter
slightly protruding end of the fuse and screw the previously removed screw insert
(C) back in .
NOTE
► If the device still does not work or the fuse blows again immediately, the device
is defective . Please then contact the Service Hotline (see chapter Service) .
■ 100 │
GB
in the housing to restart the device .
contains a fuse . If the device does not function, it may be be-
out of the cigarette lighter socket .
by carefully unscrewing the ribbed screw insert (C)
to the port
, place the plug tip (B) onto the
on
CR 5 A2