Setting Up The Control Box; Mounting The Camera - Waeco RV-AMP/4 Montage- Und Bedienungsanleitung

RV-AMP4.book Seite 28 Dienstag, 31. Oktober 2006 4:20 16

Setting up the control box

7 Setting up the control box
RV-AMP/4 must be adapted to certain connection possibilites via two small dip switches.
No. in fig. 5,
Description
page 6
9 DIP switch 1 is used to set image mirroring or to set the audio
function.
This switch has no function if you are using the RV-20CFM colour
camera.
10 Dip switch 2 is used to activate the camera when the monitor is
switched on.
In default mode as a rear view system, this switch must be set to ON.
If a second video source such as a navigation system or DVD player
is connected, this switch must be set to OFF. Otherwise the camera
would be activated and in continuous operation when you switch on
the monitor. When dip switch 2 is set to OFF, the camera is activated
only when you engage the reverse gear.
➤
Set the dip switches as desired based on the table.
8

Mounting the camera

If installing the camera alters the vehicle height or length specified in the vehi-
cle documents, your vehicle must be inspected by the appropriate authorities.
Make sure that you are in possession of documents verifying that your vehi-
cles has passed this inspection.
Warning!
Select a location for the camera and attach it so securely that it cannot under
any circumstances fall off and injure bystanders (e. g. by being knocked off by
branches brushing the roof of the vehicle).
Observe the following instructions when mounting the camera:
➤
To provide a suitable viewing angle, the camera must be attached at a height of at
least 2 m.
Ensure that you have a firm place from which to work when mounting the camera.
➤
Ensure that the installation location of the camera is sufficiently firm (e. g. to prevent
the camera from being knocked down by any branches that may brush over the roof
of the vehicle).
28
In default mode as a rear view camera, this switch must be set
to OFF. The image is mirrored and then functions as if you were
looking into the rear-view mirror.
To transmit audio signals (for cameras with a microphone,
e.g. RV-26/M), the switch must be set to OFF.
PerfectView Accessory