Installation And Connection; Tools Required - Waeco RV-AMP/4 Montage- Und Bedienungsanleitung

RV-AMP4.book Seite 26 Dienstag, 31. Oktober 2006 4:20 16

Installation and connection

6 Installation and connection
6.1

Tools required

For installation and assembly you require the following tools:
Measuring ruler (see fig. 3.4, page 4)
Centre punch (see fig. 3.5, page 4)
Hammer (see fig. 3.6, page 4)
Drill bit set (see fig. 3.7, page 4)
Drill (see fig. 3.8, page 4)
Screwdriver (see fig. 3.9, page 4)
For making and testing the electrical connection the following tools are required:
Diode test lamp (see fig. 3.1, page 4) or voltmeter (see fig. 3.2, page 4)
Insulating tape
Heat shrinking sleeve
Hot air blower (see fig. 3.10, page 4)
Crimping tool (see fig. 3.11, page 4)
Soldering iron, if required (see fig. 3.12, page 4)
Solder, if required (see fig. 3.13, page 4)
Cable bushing sleeves, if required
6.2 Installing and connecting the control box
The control box is supplied ready for installation.
➤
Install the control box in a location protected from water near the monitor, prefera-
bly under the dashboard.
Make sure to consider the length of the cable.
➤
Attach the control box using the supplied screws.
➤
Insert the plug and the cable set in the connection provided (12 - 24V) on the switch
box.
➤
Connect the brown cable (see fig. 5.1, page 6) to earth.
➤
Connect the red cable (see fig. 5.2, page 6) to an active positive line (such as termi-
nal 15).
Warning!
Ensure that you connect the control cables correctly to + PLUS an not to
earth. Connecting the control cables to earth can damage the device.
➤
Connect the green cable (see fig. 5.5, page 6) to the positive cable of the reversing
light.
26
PerfectView Accessory