Moser 4320 Gebrauchsanweisung Seite 8

ENGLISH
· The hairdryer is fitted with an overheat protection facility. Should the
de
appliance overheat, the heating process is interrupted and only cold
air flows out. After the appliance has cooled down, the heating element
en
will switch on again automatically.
· As an additional safety measure, it is recommended that a tested
fr
residual current appliance (RCD) with a residual operating current of
not more than 30 mA be installed in the circuit. Ask the electrician who
it
installed your appliance for advice.
es
· Disconnect from the mains before cleaning or servicing the appliance.
· Never use the appliance if it is defective, if it has fallen onto the floor
pt
or if the mains cable is damaged. A damaged mains cable may only be
replaced by an authorised service centre or another similarly qualified
nl
person in order to avoid hazards.
· Repairs may only be performed at an authorised service centre using
sv
original parts. Only specialists properly trained in the handling of elec-
trotechnical appliances may repair electrical equipment.
no
· Only use accessories recommended by the manufacturer.
fi
· When disconnecting the appliance from the mains, never pull on the
mains cable or on the appliance itself.
tr
· Do not wind the mains cable around the appliance.
· Keep the mains cable and appliance away from hot surfaces.
pl
· Make sure that the mains cable is not twisted or kinked when used
and stored.
cs
· When using a diffuser, never set the hairdryer to a high temperature as
this could result in the overheating of the diffuser or hairdryer.
sk
· Never insert or allow objects to fall into the openings of the appliance.
hr · Never use the product in an environment with a high concentration of
aerosol (spray) products or in which oxygen is released.
hu
· The appliance is safety insulated and radio screened. It meets the
requirements of EU Directive 2004/108/EC regarding electromagnetic
sl
compatibility and EC Low Voltage Directive 2006/95/EC.
· We are not liable for damage caused as a result of improper use or
ro
failure to observe these operating instructions.
bg
ru
uk
el
ar
8