User Information; Installation; Warranty Information - Siko AH36M Benutzerinformation

User Information

AH36M
Absolute encoder
ENGLISH

1. Warranty information

• In order to carry out installation correctly, we
strongly recommend this document is read very
carefully. This will ensure your own safety and the
operating reliability of the device.
• Your device has been quality controlled, tested and
is ready for use. Please observe all warnings and
information which are marked either directly on
the device or specified in this document.
• Warranty can only be claimed for components sup-
plied by SIKO GmbH. If the system is used together
with other products, there is no warranty for the
complete system.
• Repairs should be carried out only at our works.
If any information is missing or unclear, please
contact the SIKO sales staff.
• Keep away foreign magnets.

2. Identification
Please check the particular type of unit and type
number from the identification plate. Type number
and the corresponding version are indicated in the
AH36M Datum 29.11.2011

delivery documentation.
e. g. AH36M-0023

3. Installation

For mounting, the degree of protection specified
must be observed. If necessary, protect the unit
against environmental influences such as sprayed
water, dust, knocks, extreme temperatures.
Important information! Radial shaft sealings are
subject to wear! Protection class therefore depends
on life and condition of sealings.
Mounting instructions
Please handle the encoder carefully as it is a high-
precision device.
Especially do not:
• disassemble or open the encoder (unless stipulated
in this brochure).
• link encoder's shaft with rigid couplings as this
would expose the encoder's shaft bearing to
high forces.
• knock on casing or shaft; the encoder's inner
components could be damaged.
• machine (bore, mill ...) flange or shaft. This could
lead to severe damage inside the encoder.
• exceed the values for the maximum axial and
radial shaft load.
• mount the encoder incorrectly.
Otherwise manufacturer's warranty will be invalida-
ted!
NEVER ...
Fig. 1: Mounting instructions
Art.Nr. 85966
version number
type of unit
Änd. Stand 452/11 5