Silvercrest IAN 293999 Bedienungs- Und Sicherheitshinweise Seite 37

3. Connecting the cables (Fig. F)
Plug the camera connection cable
connection port on the PoE adaptor cable
13
.
14
Connect the plug of the power adaptor
the connection for the power adaptor
Plug the power adaptor
appropriate indoor power supply .
NOTE: The status LED
that the product is connected to the power supply .
4. Router (Fig. F)
NOTE: Before you can use the camera
wirelessly, it must be set up through a cable
connection .
Preparation:
–Check if your router (not included) has an
active internet connection .
–Connect your smart device with the router .
–Read your router's instruction manual, if
needed .
Connect the Ethernet cable (not included) to a
free slot on the router .
Connect the other end of the Ethernet cable
into the connection port
adaptor cable .
14
NOTE: The camera needs about 1 minute of
a startup time after it is powered on . The product
is ready for setup when the status LED
continuously .
5. Configuring a new camera
Download and install the "Silvercrest IP Cam
S-K 1920" application on your smart device .
The application is available in the App Store
for iOS devices and in the Google Play
store for Android devices .
Alternatively scan the appropriate QR code
for your smart device operating system:
into its
10
to
17
.
16
into an
17
lights up to indicate
7
15 of the PoE
flashes
7
®
TM
Open the application on your smart device
and tap icon to add the camera .
NOTE: Follow the installation steps of the
app during Wi-Fi setup .
Select "Outdoor Pan Tilt Camera" .
Tap "Configure a new Camera" .
Tap "Next" .
Tap "Next" . The application searches for the
camera by its identification code (DID) .
NOTE: The DID code is located under the
QR code sticker on the main unit (near to the
rating plate) .
Once the camera has been found, assign a
name to the camera and set a new admin
password .
NOTE: For your own privacy and safety, you
are required to setup a secure 12-digit password
consisting of uppercase and lowercase letters,
numbers, and special characters . Keep the
password well for future need .
The setup process brings you to the Wi-Fi
connection setup .
The Wi-Fi router default password is usually
labelled at the back of the router . If you have
changed the default password to a custom
one, make sure the password is correct before
you start the Wi-Fi setup of the camera .
GB/IE 37