Tagu 23PF1A Anleitung Seite 19

AUTOMATIC HEATING SCHEDULE (AHS)
INTRODUCTION
You can set the heater to turn on/off at specific temperature for specific times. You can set up to 7
different heating presets and individually assign to each one of them multiple days of the week.
A heating preset defines the start time, end time, room temperature and working days.
EXAMPLE:
Preset 1 starts at 18:00 and stops at 22:00 , temperature of 22°C , Monday to Friday
Preset 2 starts at 10:00 and stops at 22:00, temperature of 22°C, Saturday and Sunday
SETTING THE PRESETS
There are 7 different presets which you can individually set. To begin setup for the first
preset, during normal operation, press the OK BUTTON to activate the display and after that press the
SETTING BUTTON :
SET THE START TIME: The STATUS INDICATOR should show ON. Press the PLUS
BUTTON to set the hour and the MINUS BUTTON to set the minutes.
SELECT THE DAYS: Press the DAY BUTTON to navigate to a certain day and use the PLUS
BUTTON to select it and the MINUS BUTTON to deselect it.
SET THE TEMPERATURE: Press the HEATER BUTTON to set the temperature. Press
the PLIUS BUTTON to raise the temperature and MINUS BUTTON to lower it.
SET THE END TIME: Press the SETTING BUTTON to navigate to end time. The
STATUS INDICATOR should show OFF. Press the PLUS BUTTON to set the hour and the MINUS
BUTTON to set the minutes.
NAVIGATE TO NEXT PRESET: Use the SETTING BUTTON to navigate through preset start time,
preset end time and next preset.
ACTIVATING A PRESET
During normal operation, repeatedly press the DAY BUTTON on the remote to select the desired
preset and press the OK BUTTON to activate it and heating schedule will be set.
AUTO MODE
8 is the AUTO MODE. By selecting the 8 mode, all your presets will activate at the same time, one after
the other. This mode is useful if you need multiple presets to run during the same day.
NOTE: When using this mode, make sure the presets don't have overlapping hours.
DEACTIVATING A PRESET
Press the CANCEL BUTTON to deactivate a preset and turn off the automatic heating schedule.
NOTE: When using the automatic heating schedule manual heating and sleep timer will be disabled
and will not work anymore until all presets have been deactivated.
NOTE: The Automatic Heating Schedule (AHS) will work only if the clock has been set.
NOTE: If there is a power outage or you unplug the firebox the system resets and you will have to set
AHS all over again.
19
EN