Tagu 23PF1A Anleitung Seite 18

ON/OFF
Press the POWER BUTTON on the control panel or the remote control to turn the unit ON or OFF.
When turned OFF the embers of the log set will not immediately go out. This is a designed feature
to represent the embers of the fire slowly fading out.
FLAME BRIGHTNESS
Press the FLAME BUTTON on the control panel or the remote control to raise or lower the level of
flame brightness from 1 to 4. Level 5 will make the flame automatically glow
dimmer and brighter creating a realistic fire effect.
HEATING
Press the HEATER BUTTON on the control panel or the remote control to turn the heating ON/OFF.
After the heater has been turned off the fan may still run to prevent over heating.
TEMPERATURE AND THERMOSTAT
The thermostat setting range is 17°C - 27°C or 62°F - 82°F or constantly ON. If the room has
reached the selected temperature the heater will automatically shut down and turn back on if
needed. While the heating is on you can adjust the temperature of the thermostat:
USING THE CONTROL PANEL: press and hold the HEATER BUTTON for 3 seconds and after
that press the button again to change the temperature. After selecting the desired value, press the
FLAME BUTTON to save the setting and return to normal operation.
USING THE REMOTE CONTROL: press the PLUS BUTTON to raise the temperature and the
MINUS BUTTON to lower the temperature.
SLEEP TIMER
This allows you to set the fireplace to automatically shut OFF after the amount of time displayed
on the screen. Press the TIMER BUTTON on the remote control to set and cycle through the timer
setting from 1-9 hours and off. Select the desired amount of hours and the firebox will automatically
shut OFF after that selected amount of time.
RELAX
Not everything in life has a clear purpose. Press the RELAX BUTTON on the remote control to... sit
back and relax. You can press this button how many times you want and nothing bad will happen. It
acts like a stress relief button :)
CELSIUS TO FAHRENHEIT
To change between °C and °F, while the heater is ON, press and hold the FLAME BUTTON on the
control panel for 3 seconds.
OPEN WINDOW DETECTION
Should a window or door be accidentally left open for over 30 minutes, the heater will
detect the sudden change in temperature and turn OFF automatically, displaying OP on the screen.
To return to normal operation, press and hold the HEATER BUTTON for 3 seconds or turn the unit
OFF and back ON.
18