Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Circle-Beam Infrared Thermometer
Instruction manual - Infrared thermometer
1. Before you use this product
Please make sure you read the instruction manual carefully.
Following and respecting the instructions in your manual will prevent damage to your
instrument and loss of your statutory rights arising from defects due to incorrect use.
We shall not be liable for any damage occurring as a result of non following of these
instructions. Likewise, we take no responsibility for any incorrect readings or for any
consequences resulting from them.
Please take particular note of the safety advice!
Please keep this instruction manual safe for future reference.
2. For your safety
•
The product should only be used as described within these instructions.
•
Unauthorized repairs, alterations or changes to the product are prohibited.
•
The product is not recommended for taking body temperature.
Attention: Laser class II Never look directly into the laser beam.
Do not direct the laser beam into the eyes of a person or animal.
It can cause permanent damage to the eye.
Wavelength: 630 - 670 nm Output: <1mW
EN 60825-1:1994/A11:1996/A2:2001/A1:2002
Caution!
Risk of injury:
Risk of injury:
•
Do not aim too close at hot or dangerous targets.
•
Keep this device and the battery out of the reach of children.
•
Batteries must not be thrown into a fi re, short-circuited, taken apart or
recharged. Risk of explosion!
•
Batteries contain harmful acids. Low batteries should be changed as soon as
possible to prevent damage caused by leaking.
•
Wear chemical-resistant protective gloves and safety glasses when handling
leaking batteries.
Important information on product safety!
•
Do not place your device near extreme temperatures, vibrations or shocks.
•
Protect the device from high or abrupt room temperature changes.
•
Do not leave the device near objects of high temperature.
•
Do not immerse the device in water. Water can penetrate and cause mal-
function.
•
Protect it from moisture.
•
Check the housing before using the device. Do not use the device if it seems
to be damaged. Check for cracks or missing plastic parts.
•
Steam, dust, smoke, etc., can prevent accurate measurement by obstructing
the unit's optics.
7
Werbung
