Aqua Medic DC Runner 1.2 Bedienungsanleitung Seite 7

0 - 10 V: The pumps must be operated with at least 60% power, otherwise damage will occur. Short pulse rates
are not possible due to the start-up delay on the pumps.
Press the FEED button until 4 LEDs (Fig. 4, No. 2) light up in the middle to activate the 0 - 10 V socket. In the
same way, the 0 - 10 V output can be deactivated again.
Fig. 4: DC Runner Controller
1. Feed button
2. LEDs
By keeping the minus and FEED buttons pressed and hold until the LEDs flash once, the keyboard of the
controller can be locked or unlocked.
5. Maintenance / Cleaning
From time to time, the pump needs to be cleaned. For cleaning, do the following:
plate. Then, turn the basket and take it off the pump. Now, the complete impeller can be taken out.
cleaned under running water and then be
the impeller goes into the socket of the respective bearing.
6. Failures
The pump is designed to have a low maintenance requirement and under normal conditions will be very reliable,
provided it is protected from contamination. If the pump gets noisy, the suction basket and the propeller need
to be cleaned or the impeller and bearings need to be replaced.
7. Warranty conditions
AB Aqua Medic GmbH grants the first-time user a 24-month guarantee from the date of purchase on all material
and manufacturing defects of the device. Incidentally, the consumer has legal rights; these are not limited by
this warranty. This warranty does not cover user serviceable parts, due to normal wear & tear ie: impellers or
drive wheels etc. The original invoice or receipt is required as proof of purchase. During the warranty period,
we will repair the product for free by installing new or renewed parts. This warranty only covers material and
processing faults that occur when used as intended. It does not apply to damage caused by transport, improper
handling, incorrect installation, negligence, interference or repairs made by unauthorized persons. In case of
a fault with the unit during or after the warranty period, please contact your dealer. All further steps
are clarified between the dealer and AB Aqua Medic. All complaints and returns that are not sent to
us via specialist dealers cannot be processed. AB Aqua Medic is not liable for consequential damages
resulting from the use of any of our products.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
3. Power supply
4. 0 - 10 V socket
re-assembled. When assembling, make sure that the ceramic shaft of
- Technical changes reserved – 03/2019
First of all, remove the bottom
It can be
7