MaxPro MPCD12VDQF/2 Bedienungsanleitung Seite 7

hexagonal shaft.
hten the drill chuck so that the drill cutter is firmly clamped. Rotate the drill chuck in the opposite
direction when you wish to change the cutter.
3
Always follow the safety notes and the relevant safety code.
Hold the appliance firmly and press the drill steadily onto the work piece. Do not overload the appliance.
Only use drills with no visible wear. Worn drills will have a bad effect on the functioning of the appliance.
Adjusting the torque
The appliance has 16 different torque settings with which to set the power for driving and removing
screws.
Set the torque adjustment ring to the desired position. The available torque settings are indicated on the
adjustment ring by the numbers 1 to 15 and by dots between the figures to define intermediate settings
(16 in total).
sett g t e oto s ps setting if the motor slips.
4
Driving and removing screws
e direction reversing switch to position 'L' in order to drive screws.
e the torque adjustment ring to the drilling position.
Ensure that the direction reversing switch is always set to 'L' during drilling.
5
Switching the device on and off
7
Cordless drill/driver MPCD12VDQF/2 User Manual
by rotating the handgrip.
L
. It regulates the speed of the appliance by transmitting power to the switch.
to halt the drill chuck immediately which will no longer run on.
as possible when using the screwdriver. Select a higher
'R' in order to remove screws. Drilling
Stop
GB
R