Health Hazard; Operating Determinations - EuroLite LED FE-41 Flower Effect Bedienungsanleitung

Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer
will not accept liability for any resulting defects or problems.
Please make sure that there are no obvious transport damages. Should you notice any damages on the
power unit or on the housing, do not take the device into operation and immediately consult your local
dealer.
The device falls under protection-class III. The device may only be recharged with the enclosed power unit.
Always plug in the power unit last. The power plug must always be inserted without force. Make sure that the
plug is connected properly with the outlet.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
Never look directly into the light source, as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a lighting effect for creating decorative effects. This product is only allowed to be operated with
an alternating voltage of 100-240 V, 50/60 Hz (via enclosed power unit).
The power unit falls under protection-class 2 and the device under protection-class 3.
This device was designed for indoor use only. The device must never be installed in damp rooms (e.g.
bathroom, kitchen).
The F-symbol means: this device can be installed on normal inflammable surfaces.
- - -m
The symbol
between light-output and the illuminated surface must be more than the given value.
The maximum ambient temperature T
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
fixture.
This device must never be operated or stockpiled in surroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.

HEALTH HAZARD!

determines the minimum distance from lighted objects. The minimum distance
must never be exceeded.
a
9/12
00100258.DOCX, Version 1.0