Werbung
How to adjust the transmitter frequency
Adjust the desired transmitter frequency with the switch
switch corresponds to a transmitter frequency. You will find the exact frequency
on the type plate in the battery compartment.
Take care that the transmitter frequency and the received frequency selected
at the receiver do correspond.
A small screw driver (breadth approx. 2 mm) or the end of the wire antenna
which is shaped like a small blade is suitable tools for the selection.
How to switch on / how to select sensitivity
The ON/OFF-switch
and the selector switch
bottom of the housing.
The ON/OFF-switch which is used more frequently is positioned slightly
above the selector switch.
After having switched on the transmitter you must wait approx. 2 seconds as the
transmitter requires this time for adjusting to the chosen frequency. (PLL-rest.).
The AF signal is attenuated if the selector switch for the sensitivity
to „
". Close-miking can thereby not result in overmodulation.
LOW
Attenuation for SKM 1030: approx. 14 dB
Attenuation for SKM 1032: approx. 20 dB
18
. Each number on the
are positioned in a cavity on the
is switched
Werbung
