Braun FaceSpa Pro 910 Bedienungsanleitung Seite 10

Charging
Before use, charge the appliance for 1 hour using the special cord set (6).
Unplug after charging and use the appliance cordless.
Pilot light (3)
Flashing white
Constant white 5 sec, then turns off
Yellow flashing
Yellow fast flashing
The best environmental temperature for charging, using and storing is between 15 and
30 °C. Beyond this range, charging might take longer.
In case of overheating/motor blocking, the red pilot light flashes/shines constantly and
the motor turns off. Wait for the appliance to cool down and the red light to turn off
before switching on again.
Switch (4)
Press the switch centre (I) to turn the appliance on and off.
Additional switch functions depend on the head attached:
Epilation head (2)
Brush attachment* (7,8)
MicroVibration head* (9)
* Both the Brush attachment and the MicroVibration head are provided with a
treatment timer. A short pause after every 20 seconds of operation indicates that it is
time to move on to the next face zone (left cheek, right cheek, forehead).
Travel lock
Press the switch centre (I) 3 seconds to lock the appliance. A beep confirms that the
travel lock is activated. To unlock, press the switch 3 seconds. 3 beeps will sound when
your unlock attempt failed. Try again or simply connect the appliance to the mains.
Using the epilation head (dry use only)
• Before use, make sure your skin and the epilation head are thoroughly clean.
• Hold the appliance with the tweezers against a section of skin that you keep
stretched with your free hand. Carefully guide it with gentle pressure against the
direction of hair growth. Do not press too hard as this may lead to skin injury. To
stretch the upper lip area, use your tongue to push from below.
10
Charging status
Charging is in progress
Fully charged
Charging level has dropped below 10 %.
Motor has stopped, please recharge.
Left rotation
Speed 1
Right rotation
Speed 2