i-tec USB-C Smart Charger 60W Gebrauchsanweisung Seite 8

i-tec USB-C Smart Charger 60W
Environment
Operating values: 0 C - 40 C
Relative humidity: 20% - 80%
Physical
Dimensions of the adapter: 114x70x17mm
Weight: 164 g
USING THE POWER ADAPTER
Connecting the universal adapter to the device:
1. Connect the adapter to the 100/230V grid using the power supply cable.
2. Then connect one end of the USB-C cable to the USB-C port on the power
adapter.
3. Connect the second end of the USB-C cable to the charging USB-C port
on the device.
4. The LED indicator will go on and charging will start; charging may be
checked by a standard way on the charged device.
Note: For charging of mobile phones and similar devices with USB chargers
you can use the USB-A port of the adapter. Charging via the USB-A port
works if supported by the charged mobile phone (device).
Important safety measures:
Do not pull the power supply cable from the socket outlet by pulling the
ź
cable.
Do not connect the power supply cable to the socket outlet if your hands
ź
are wet and if you find out that the power supply cable is damaged (short-
circuited, burned PVC cover). Also immediately disconnect from the grid
if you smell burning.
Do not disassemble this device, do not make any modifications – risk of
ź
fire, injury or damage to personal property. Entrust all repairs to the
manufacturer (ComDis s.r.o.).
Do not expose to direct sunlight, do not place it on heating elements or
ź
on any other source of heat. Do not cover it with paper or any other
material to allow circulation of air.
Do not use in an environment with temperature below 0°C and higher
ź
than 40°C. Use in ventilated areas.
Do not use the adapter with damaged supply cord, damaged output
ź
cable or fuses.
EN
07
o o