Cleaning And Maintenance - Soba BS310 Gebrauchsanleitung

BS310 PRESSURE STEAM IRONING STATION

CLEANING AND MAINTENANCE

• Switch off after use and remove the plug from the socket.
• Always allow the iron to cool before putting it away.
• The water reservoir need not be emptied after ironing.
• Wipe the casing (12) from time to time with a damp cloth and rub dry.
Cleaning the sole
• When you have finished ironing place the iron on the rest. Take care that there
are no traces of condensation under the sole plate as this could cause staining.
• Simply wipe the cold sole plate with a damp cloth to keep it clean. Descaling
agents should not be used to clean the appliance.
• The iron should not be run over zips, buttons, rings, eyes etc. to prevent
scratching the sole plate.
Cleaning the pressure steam unit
It is advisable to rinse out the steam pressure unit from time to time. Do not use
anything but water in the steam pressure unit (never detergents). All liability is
excluded if the instructions are not followed.
Do not screw off the tank cap until the pressure unit is no longer under
pressure.
• Make sure the mains plug has been disconnected.
• Unscrew the reservoir safety cap (10).
• Turn the steam unit upside down and empty it into the sink. This will let the
deposits run off with the water.
• Screw the tank cap (10) back on.
5
INSTRUCTIONS