Soba BS310 Gebrauchsanleitung Seite 4

BS310 PRESSURE STEAM IRONING STATION
DESCRIPTION
1. On/Off switch for pressure steam unit
2. On/Off switch for iron
3. Warning light "Reservoir empty"
4. Warning light "steam ready"
5. Steam volume gauge
6. Thermostat dial for iron
7. Iron temperature control light
8. Steam jet button
9. Continuous steam button
10. Tank cap
11. Rest surface for iron
12. Plastic casing
13. Lead with plug
14. Power cable (steam hose + lead)
INSTRUCTIONS
Dear Customer,
Congratulations on your purchase of the SOBA pressure steam ironing station.
Please read these Instructions before using the ironing station for the first time. They
contain a lot of useful information.
IMPORTANT
Water
Please read the enclosed fact sheet about the kalkex12 rapid water softener. Use
ordinary tap water. If the water is very hard (water hardness over 27° dH) we
recommend using de-mineralised water. The steam generator system could be
damaged by using water treated by another system. e.g. by using softening and
water preparation equipment, incorrectly introduced filters or by using additives. This
could cause leakage and soiling of the ironing.
Starting up for the first time
A trace of smoke may form when heating up for the first time. This disappears after a
few minutes. We recommend that you start ironing with the less sensitive fabrics.
Rest surface for iron
The iron should always be put down on the iron rest surface(11). Do not place it on
rough surfaces.
2
INSTRUCTIONS