Soba BS310 Gebrauchsanleitung Seite 6

BS310 PRESSURE STEAM IRONING STATION
Ironing with Steam
• Check that the garment you want to iron is suitable for steam ironing.
• Screw off the tank cap (10) and pour in 1 litre of water.
• Screw on the tank cap (10) and plug in to the mains (13).
• Press the steam pressure station button (1) and the iron button (2).
• Adjust the thermostat dial (6) to the required temperature. The steam range is
marked in blue on the thermostat dial.
• The pressure steam unit reaches optimum ironing pressure in 10 minutes.
• The "steam ready" light (4) lights up when the unit is ready to start ironing. It is
perfectly normal for the lamp to switch off again. The "steam ready" light switches
off and on while you are ironing without affecting the ironing in anyway.
• Suits and jackets can be ironed or freshened up on the hanger when using this
pressure steam ironing station.
Steam volume control dial (5), steam jet button (8) and continuous steam
button (9)
• Press the steam jet button (8) for steam pressure. Click in the continuous steam
button (9) for a steady flow of steam.
• Press the steam jet button (8) repeatedly, at short intervals, to let the steam out
of the iron and allow the ironing to dry.
• The desired steam volume can be set with the steam volume switch (5). Turning
clockwise increases the steam volume, turning anticlockwise reduces the
steam.
• If the "tank empty" lamp (3) the water reservoir is empty and must be topped
up. Continuing to iron, without topping up with water, can damage the
steam system.
Ironing Vertically
Suits and jackets can be ironed or freshened up on the hanger using this pressure
steam ironing station.
• Set the thermostat dial on the iron (6) to maximum temperature.
• Hang the garment on a clothes hanger and hold it lightly with one hand.
• Press the steam jet button (8) and pass the iron from top to bottom along the
material.
Important: pass the sole direct along the material for cottons and linens. On the
contrary, for delicate fabrics the sole of the iron should be kept several centimetres
away from the material.
Ironing without steam
Connect the unit to the mains, press the iron On/Off switch (2). Select the required
temperature with the thermostat dial (6). The control light (7) goes out as soon as
the required temperature is reached. The steam jet button should not be pressed
when ironing without steam.
4
INSTRUCTIONS