Initial Operation - Winix ZERO Bedienungsanleitung

INITIAL OPERATION

Insert the power cord into an electrical
①
outlet.
Press the 'Power' button.
②
Note
③ By default, when the unit first powers on, the
mode will be set to Auto with PlasmaWave
enabled.
ˍ When in Auto mode, the fan speed will
be automatically adjusted according to
the environments air quality.
ˍ PlasmaWave ®
airborne contaminants.
Note
English
ˍ During the first 30 seconds of power up, the Air Quality
Indicator will cycle through Blue, Yellow and Red colors.
The Particle Sensors take approximately 30 seconds to
gauge the air quality in the environment, after which normal
operation will begin.
works to remove harmful
ˍ In Auto mode, as the indoor air quality improves, the fan
speed will automatically be reduced to Low.
ˍ When the unit is running, you may hear a chirping or buzzing
sound. The sound is from large particles passing through
PlasmaWave ® , it is normal and does not signify product
failure. To disable PlasmaWave
®
® , see page 12.
ZERO
9