Hitachi RAR-5E3 Bedienungsanleitung Seite 25

INFO FUNCTION
O By pressing (INFO) button, temperature around remote controller and monthly power consumption will
be displayed on the remote controller.
O
After changing the batteries, direct the remote controller towards the indoor unit and press
button.
Current calendar and clock will be transmitted from indoor unit.
O
In order to receive information from indoor unit, the distance between remote controller and receiver of indoor
units is within 2 meters.
NOTE
O
In case failure occurs to the air conditioner, by pressing
displayed.
Direct the remote controller towards the receiver of indoor unit (within 2 meters in front of indoor unit)
and press (INFO) button. Wait for 2 seconds for signal transmission.
An error code will be displayed.
Call service center and inform the error code.
Q To check temperature around remote controller
Press (INFO) button.
1
Temperature will be displayed for 10 seconds.
Q To check monthly power consumption
Direct the remote controller towards the receiver of indoor unit
(within 2 meters in front of indoor unit) and press
button. Wait for 2 seconds for signal transmission.
While temperature around remote controller is displayed, press
(INFO) button repeatedly. The display will show as below:
this month power consumption amount for heating
power consumption amount for heating
consumption amount for cooling
amount for cooling
month power consumption amount for heating ...... cyclically.
O If indication is not given, bring remote controller closer to the
receiver of the indoor unit.
O
Indicated value shall be regarded as a guide only.
Q Current calendar and clock can be retrieved
from indoor unit
Direct the remote controller towards the receiver of indoor unit
(within 2 meters in front of indoor unit) and press
button. Wait for 2 seconds for signal transmission.
Once received the current calendar and clock, check whether they
are correct or not by pressing
O
If there is no power supply to indoor unit or calendar and clock
have not been set, INFO function cannot be used for sending or
receiving information.
– 25 –
last month power consumption
temperature around remote controller
(CLOCK) button.
(INFO) button, an error code will be
(INFO)
(INFO)
last month
this month power
this
(INFO)