Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPTA-Connector
Making the Connection
Step 1
Step 2
8
Installation and Starting Up
1. Connect the female and male OPTA connectors with the same colour tag.
These colour codes ensure the correct allocation of the ports.
Orange: Feed
Blue:
Retentate
Yellow: Permeate
Male connector
Remove the protective caps by pulling on the flaps that are located at the bottom
of each cap. After removal of the caps membrane tapes will be released. These
membrane tapes should always hang down to assure the correct assembly of the
male and female connector bodies.
Male connector
Retract the collar that is fixed on the female connector to prepare for assembly.
Assemble the two connectors by sliding the two connector heads together until the
two pins of the male connector click into place. Once the female and the male con-
nectors are assembled they should not be disassembled. The integrity of the male and
female connectors is ensured by the membrane sterile barrier. Each membrane tape is
equipped with a mating gripper to assure simultaneous removal of the sterile barrier.
Female connector
Female connector
"Click"
Werbung
