RX 5 M |
Instruction manual
6. Mounting of the dispenser
6. Mounting the dispenser
This dispenser is for wall-mounting only.
Follow the instructions listed below:
1
1.
2
14
CAUTION
2.
•
NOTICE
•
•
•
•
•
Do not install the appliance in narrow entrances and passage-
ways! Mount the dispenser 1.2m from the floor to the
bottom of the dispenser
Check the suitability of the wall before mounting!
When choosing where to mount the appliance, please consider
ease of access for filling! Allow 60 mm min. distance at the top
of the back plate. Allow 135 mm min. distance from the bottom
of the back plate to a table top or bench.
The back plate must be mounted to a flat wall using the 3 screws
provided. (Fig. 1)
The dispenser should be fitted against the back plate and moved
vertically down to engage the backplate lock. (Fig. 1)
To remove the dispenser from the backplate, press plastic spring
tab through hole on the dispenser and lift upwards. (Fig. 2)