Yamaha C-5000 Bedienungsanleitung Seite 11

C. BAL 1/BAL 2 jacks
These are two sets of XLR-type balanced input jacks. If
the INPUT selector is set to BAL 1 or BAL 2, signals at
the corresponding XLR jacks will be the input source.
Note
Set the ATTENUATOR selector and PHASE selector
appropriately for the playback components that are
connected to the unit .
D.
ATTENUATOR selector
Enables you to set the allowable input level for the XLR-
type balanced input jacks (BAL 1 and BAL 2 jacks). For
more information, refer to "Adjusting the volume level"
(page 30).
BYPASS: The allowable input level will not change.
Usually select this option.
ATT (−6 dB): The input gain will be lowered by 6 dB
to raise the allowable input level. Select this option if
the audio output from the connected component sounds
distorted.
E. PHASE selector
Specifies the HOT pin position for the XLR-type
balanced input jacks (BAL 1 and BAL 2 jacks).
NORMAL: Pin #2 is specified as HOT.
INV : Pin #3 is specified as HOT.
For more information, refer to "Balanced and unbalanced
connections" (page 14).
F. TUNER jacks
These are RCA input jacks. If the INPUT selector is set
to TUNER, signals at these jacks will be the input source.
Connect your tuner here.
11