THOMSON CR50 Bedienungsanleitung Seite 14

9. SNOOZE / DIMMER BUTTON...
- When you are wakened by the alarm but wish to sleep for a few more minutes, simply touch the
"SNOOZE" button and it will turn the alarm off for 9 minutes before the music or buzzer sound
again. This can be repeated.
- Press the button repeatedly to choose the brightness of the LED display. 3 levels can be selected
such as High, Low and Off.
TO SET THE TIME
1. In standby mode, long press the TIME SET / MEMORY button to trigger TIME SET MODE and the
display will start blinking. Press the HOUR / REVERSE button to set the Hour and the MINUTE /
FORWARD button to set the Minute.
Note:
- Keep pressing the HOUR / REVERSE button or the MINUTE / FORWARD button if you run past
the correct time.
- Time is displayed in 24-hour clock format.
TO SET THE ALARM
- When the device is in standby mode,
Press the ALARM 1 / VOLUME- button to turn Alarm 1 on or off. This is indicated by the light
next to Alarm 1 on the display.
Long press the ALARM 1 / VOLUME- button to set Alarm 1's time. When the time display is
blinking after the long press, press the HOUR / REVERSE button to set the HOUR and the
MINUTE / FORWARD button to set the MINUTE.
- Note: This is the same as setting up Alarm 2.
TO TURN OFF THE ALARM
- In standby mode,
Press the ALARM 1 / VOLUME- button to turn Alarm 1 off.
The indicator light of Alarm 1 will disappear.
- Note: This is the same as setting up Alarm 2.
TO PLAY THE RADIO
1. Press the STANDBY button to turn on the unit.
2. Use the HOUR / REVERSE button and the MINUTE / FORWARD button to adjust the radio
frequency as instructed above.
3. Use the ALARM 1 / VOLUME- button and the ALARM 2 / VOLUME+ button to adjust the volume
as instructed above.
4. Press the STANDBY button again to turn off the unit.
TO WAKE UP TO RADIO/BUZZER
1. For Alarm 1, set the alarm as previously instructed.
2. After setting the time, press again the ALARM 1 / VOLUME- button and the radio frequency is
shown.
- Use the HOUR / REVERSE button and the MINUTE / FORWARD button to choose to wake up to
Radio (displayed as frequency) or Buzzer (displayed as bU)
3. Press the ALARM 1 / VOLUME- button again to exit the ALARM SETTING MODE.
Note: This is the same as Alarm 2.
- EN 5 -