Owners Manual; Saving Energy With Your Silensorpro; Pre-Start Up Checklist - Davey SilensorPRO SP200BT Installation Und Betriebsanleitung

4. OWNERS MANUAL

This SilensorPRO is Bluetooth enabled, so you will be able to set and control the pump functions from your
smart device. Bluetooth is a wireless communication protocol that enables communication between devices.
This function is supported by any device that can download an app from IOS or Android App Store.
Read these instructions in their entirety before switching on this pump. If you are uncertain as to any of these
installation and operating instructions, please contact Davey as listed on the back of this document.
Every SilensorPRO is thoroughly water tested against a number of flow, pressure, voltage, current and
mechanical performance parameters. Davey's advanced pump manufacturing technology provides reliable
and efficient pumping performance that lasts and lasts.

Saving energy with your SilensorPRO

The Davey variable speed pump is a super-efficient pump utilising a very clever, state of the art infinitely
variable AC motor that provides lower levels of noise, lower operating costs and lower greenhouse emissions
than traditional pool pumps.
Due to its ability to run at lower speeds than conventional pumps, your pump will also experience less
mechanical wear and tear due to less stress on the internal mechanical components. To achieve energy
efficient pumping is easy. Simply run the filtration pump at a lower speed but run it for longer than a
conventional fixed speed pump to "turn over" your pool water for adequate filtration and sanitisation. The
result is lower energy use and up to 70% lower operational costs.
The SilensorPRO has adjustable speed settings, so you can vary the speed you circulate your pool or spa
water at. Speeds can be adjusted to power a suction pool cleaner, in-floor cleaning system & pool heaters. A
backwash setting on the pump can be selected to backwash a media filter.
What to expect with the SilensorPRO (energy efficient operation) on your pool:
• If your SilensorPRO pump is replacing a traditional AC motor pump, you may will need to run it longer than
your old fixed speed pump. This is NORMAL and you will save energy when using lower speed settings.
• You may also notice that the pressure gauge on your filter is indicating a much lower pressure than you are
used to. This is also NORMAL. The lower system pressure is simply a result of the lower speed and flow
rate produced by the pump.
• While running at the lower speed settings you will also notice a significant reduction in pump noise. This is
a major benefit for you as it allows you to run your SilensorPRO during off peak electricity tariffs, which will
also assist in the reduction of your operating costs. Plus, you will also have much happier neighbours.
Many pool products rely on minimum flow rates for best operation and/or efficiency. If you are using low flow
settings on the SilensorPRO (e.g. speed 1 to 4) Davey recommends that you check the compatibility of the
speed or minimum flow rate required to run specific pool equipment such as:
• Suction pool cleaners;
• Ozone generators;
• Heating systems;
• Salt water chlorinator cells;
• In-floor pool cleaning systems.

Pre-start up checklist

• Speed setting chosen is a compatible setting with other pool equipment;
• The pump is installed in a safe and dry environment;
• The pump enclosure has adequate drainage in the event of leakage;
• Any transport plugs are removed;
• The pipe-work is correctly sealed and supported;
• The pump is primed correctly;
• The power supply is correctly connected;
• All steps have been taken for safe operation;
• The filter has been plumbed with 50/63mm pipe;
• The (app) schedule settings correspond with any other times in the system.
7
English