Prüfen der Genauigkeit Stellen Sie den Rotationslaser auf einem Stativ in einem Abstand von 50 m zu einer Wand. Die Tastatur des Rotationslaser zeigt zur Wand. Schalten Sie das Gerät ein. Warten Sie bis zum Abschluss der Selbstnivellierung. Wählen Sie mit der Fernbedienung den Linienmodus. Bewegen Sie die Laserlinie zur Wand.
Seite 3
Checking the accuracy Mount the rotary laser on a tripod 50 m to a wall. Keyboard should point to the wall. Turn power on. Wait until self-levelling is finished. Choose line mode. With remote control move the dot to the wall. Mark the vertical middle of the laser line on the wall as x1.
Seite 4
Justierung der Nivellierung Level Calibration Y-Achse justieren Y-axis adjusting Beide Tasten gleichzeitig für 3 Sekunden drücken. Die Tilt-Anzeige blinkt, wenn das Justierprogramm gestartet ist. Press both keys simultaneously for 3 seconds. When automatic drift system indicator winks, the instrument enters the mode of Y-axis adjusting. Mit den Pfeiltasten die Höhe des Laserstrahls korrigieren.
S2G, S3 Press both keys simultaneously for 3 seconds. When indicator winks, the instrument enters the mode of X-axis adjusting. Q3, Q3G Mit den Pfeiltasten die Höhe des Laserstrahls korrigieren. Jeder Tastendruck verändert die Höhe Schrittweise. Press the arrow keys, the instrument will adjust one step when press once.