Electrolux DUB5650HM Gebrauchsanleitung Seite 5

4.2 Charcoal filter - Type 20 LONG LIFE
- Washable activated charcoal fi lter
The charcoal fi lter can be washed once
every two months using hot water and a
suitable detergent, or in a dishwasher at
65°C (if the dishwasher is used, select the
full cycle function and leave dishes out).
Eliminate excess water without damaging
the fi lter, then remove the mattress located
inside the plastic frame and put it in the
oven for 10 minutes at 100° C to dry
completely. Replace the mattress every 3
years and when the cloth is damaged.
Type 15 - NON-washable activated
charcoal fi lter
The saturation of the charcoal fi lter
occurs after more or less prolonged use,
depending on the type of cooking and the
regularity of cleaning of the grease fi lter.
In any case it is necessary to replace the
cartridge at least every four mounths.
The charcoal fi lter may NOT be washed or
regenerated.
(1*)
(3**)
(2*)
5. CONTROLS
The hood is fi tted with a control panel with
aspiration speed selection control and a
light switch to control cooking area lights.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
The control switches are located on the
unit's front panel:
1 2
1 Suction speed (power) ON/OFF/
decrease key
2 Suction speed (power) 1 - 2 - 3 -4
increase key.
Suction speeds (powers) 3 and 4 have
a limited duration, respectively 10 and
5 minutes, after which suction speed
(power) 2 is activated.
Note: The LED on the display flashes
indicating speed timing.
3 Lighting ON/OFF key
4 "Breeze" function key (Environment
ventilation)
The hood switches on at low suction
speed (power) for about one hour and
then switches off.
5 Display
Filter saturation indicator
At regular intervals, the hood warns when
the fi lters must be serviced.
Grease fi lter saturation indicator
The set speed and the letter "F" alternate
on the display.
Carbon fi lter saturation indicator
The set speed and the letter "C" alternate
on the display.
ENGLISH
5 3 4
5