Machine Use - Nilfisk-Advance SR 1450 B-D Betriebsanleitung

MACHINE USE

Waste collection (SR 1450 D)
– Turn the accelerator lever (4, Fig. I) to the maximum speed.
– Press the switch (21, Fig. I) to operate the suction fan.
– Skirt opening: push the distributor lever (3, Fig. I).
– If the suction is diffi cult, make sure that the skirt closing panel is completely open.
– To start and lower the main and side broom, push the distributor lever (1, Fig. I).
– To start and lower the main broom only, pull the distributor lever (1, Fig. I).
When necessary, dump the hopper as follows:
WARNING!
Move the machine extremely slowly when the hopper is in the lifted position.
Maximum speed 1 km/h.
Do not dump the hopper with the machine on a slope.
– Lift the main and side brooms by pulling the distributor lever (2, Fig. I).
– Stop the broom rotation by placing the lever (1, Fig. I) to central position.
– Stop the suction fan by placing the switch (21, Fig. I) to central position.
– Close the skirt by pulling the distributor lever (3, Fig. I).
– Drive the machine to the appointed dumping area.
WARNING!
When dumping the hopper, make sure that nobody is near the machine.
– Lift the hopper by pushing the distributor lever (2, Fig. I) until the proper height for dumping is reached.
– Open the skirt by pushing the distributor lever (3, Fig. I).
– Lower the hopper by pulling the distributor lever (2, Fig. I).
– Close the skirt by pulling the distributor lever (3, Fig. I).
– Activate the fi lter shaker by pressing the switch (9, Fig. I) for approx. 20 seconds.
WARNING!
Do not activate the fi lter shaker with the hopper in the lifted position.
SR 1450 B-D 33014811(3)2010-03 A
USER MANUAL ENGLISH
15