Werbung
Verfügbare Sprachen
Verfügbare Sprachen
www.nowsonic.com
Master section
In the Master section you turn Roadtrip 52 on and off and set the level
of the stereo buss that is sent to the internal class D amplifier and the
2-way speaker system.
2
3
2
3
1
1
The LINE OUT (1) RCA outputs allow for tapping the signal in the ste-
reo buss before the MASTER VOL (3) and the class D amplifier. Via these
outputs you can feed the stereo signal of Roadtrip 52 to a subsequent
mixer, a recording device (e.g. a MD recorder) or to another Roadtrip 52.
With the TALKOVER control (2) you can set an attenuation (0 to -20dB)
for signals from the Bluetooth and line sections: the signals are attenu-
ated by this amount when the UHF receiver receives a signal from the
wireless microphone or a microphone / instrument signal is present in
the microphone / line section. Thanks to this auto mix function micro-
phone announcements are transmitted with high intelligibility over
the background music.
The MASTER VOL knob (3) controls the level of the stereo buss that is
sent to the internal amplifier and the 2-way speaker system with its
8" full-range speaker and a 1.35" tweeter. Turning the knob clockwise
increases the gain.
Finally, use the POWER switch (4) to turn Roadtrip 52 on or off. In or-
der to avoid any damages to the internal speaker, first turn down the
MASTER VOL control (3).
NOTE: The internal battery of Roadtrip 52 is only charged when the
POWER switch is set to ON. The battery will not be charged when the
power cord is connected, but Roadtrip 52 is not turned on.
Using the IR remote
Road Trip 52 is supplied with the iPod REMOTE IR remote that allows to
control the playback functions of your iPhone, iPod or iPad. The sensor
for the IR remote is located on the front in the middle between the
tweeter and the woofer. For a successful control you must direct the
remote to the IR sensor. If the device cannot be controlled, reduce the
distance between the remote control and the sensor and make sure
that the transmission is not blocked by any objects.
4
4
As the playback device is inserted into the docking station of Roadtrip
52 and the appropriate device was chosen via the selector, you can
control the following functions:
The
button opens the iTunes menu in your iPod/iPhone/iPad.
MENU
The
button selects the previous item in the iTunes menu.
The
When the desired item is selected, you can activate it with
the
button.
ENTER
Pressing the
The
button skips to the previous track.
The
button skips to the next track.
9
button selects the next item in the iTunes menu.
button will play back the selected track.
ROADTRIP 52
GB
User manual
Werbung
