Nowsonic ROADTRIP 52 Bedienungsanleitung Seite 6

www.nowsonic.com
UHF wireless section
Roadtrip 52 is supplied with a handheld microphone for wireless ope-
ration. The handheld transmitter operates in the UHF range and is per-
fectly tuned to the UHF receiver of Roadtrip 52.
1 2
1 2
3 4 5
3 4 5
The transmitter in the wireless microphone is supplied via two 1,5V
batteries (type AA). To extend the life and capacity of the battery, turn
off the wireless microphone via the ON / OFF switch when you do not
use it. However, when the batteries are exhausted, replace them with
standard type AA or rechargeable batteries. Proceed as follows:
1) Remove the transmitter at the bottom of the microphone.
2) Remove the exhausted batteries.
3) Insert the new batteries: Please take care of connecting the battery
terminals correctly.
4) Reattach the transmitter at the base of the microphone.
When you turn on the microphone via the ON / OFF switch, the Roadt-
rip 52 UHF receiver automatically connects to the wireless handheld
transmitter. Now the RF LED (2) in the UHF section and the LED left to
the IR sensor on the front of Roadtrip 52 light up: The AUDIO LED (1)
shows that the wireless microphone transmits an audio signal.
NOTE: If the RF LED (2) does not light, the receiver is actually not con-
nected. Reduce the distance between the wireless microphone and
Roadtrip 52 and make sure that the transmission is not blocked by
any objects. Also make sure that the internal batteries of the wireless
microphone are not exhausted.
With the WIRELESS MIC 1 control (3) you adjust the gain of the UHF
wireless microphone. Turning the knob clockwise increases the gain.
With the TONE control (4) you can easily alter the sound of the wireless
microphone: Turn the knob counterclockwise to attenuate the high
frequencies and to emphasize the lows. Turn the knob clockwise to
emphasize the high frequencies and to attenuate the lows.
With the ECHO control (5) you can set the volume of an internal delay
effect: Turning the knob clockwise increases the level of the delay ef-
fect relative to the microphone signal.
The WIRELESS VOL control (6) adjusts the volume of the UHF receiver
in the Master section.
6
6
iPod/iPhone/iPad-Sektion
A docking station for an iPhone (iPhone 4 or lower), iPod (4th gene-
ration or lower) or iPad is integrated in the upper side of Roadtrip 52.
Insert your device in the docking station and choose the appropriate
model via the selector. Roadtrip 52 supports the following models:
iPod
iPod nano, 4th and 5th generation
iPod Touch
iPod Touch, 2nd generation/iPod classic
iPod Touch, 4th generation
iPod classic 160GB
iPhone
iPhone 3G/3GS
iPhone 4
iPad
iPad 2
With the dock adapter, you can directly stream the music stored on
the device to Roadtrip 52 and at the same time charge your device.
Please note that you can control the transport functions either directly
at the playback device or via the included IR remote: For additional
information refer to page 9.
Start playback on your iPhone/iPod/iPad and set the volume with the
iPod VOL control (1).
7
ROADTRIP 52
User manual
1
1
GB