Driving - Vermeiren LiNX 400 Gebrauchsanweisung

 The XLR connector on the controller is to be used exclusively for the intended purpose
of charging the battery. The warranty will lapse if any unauthorized device is
connected to this port.
 Make sure that the battery charger that is used with the vehicle has a drive-inhibited
function that is correctly connected for use with the controller. This drive-inhibited
feature is intended to prevent the chair from driving while the battery is being
charged. If you are not sure, ask your dealer.
 Immediately turn the controller off and consult your service agent if the vehicle:
is damaged;
o
does not behave the same every time;
o
does not respond normally, the way you expect it to;
o
becomes hotter than normal;
o
smokes;
o
does not change its speed when you adjust the speed dial;
o
displays a fault on its fault indicator and the controller does not perform normally.
o
 Turn the controller off:
when you do not use it;
o
before you get in or out of the wheelchair;
o
if your vehicle drives by itself or against your will. When you turn the controller
o
off, the vehicle will halt.
3

Driving

1. Press the ON/OFF button.
2. If the LED on the ON/OFF button is green, the wheelchair is powered and ready to go.
3. Check the battery status indicator. Charge the battery if necessary (see § 4.3).
4. Select the driving program and set the speed range by sliding the arrow (S), see driving
functions in § 4.9.
5. Start moving the wheelchair by operating the joystick slowly forwards/backwards.
6. The speed will increase when you push the joystick further out of the centre.
7. To turn left or right, push the joystick to the left or right. Use your direction indicators
when driving outdoors, see § 4.11.
8. To brake, move the joystick to neutral position.
9. After arrival, check the battery status and press the ON/OFF button.
10. Charge the battery if necessary.
5
EN
LiNX 400
2019-01
NL
Driving