Assembly; Starting-Up The System; Maintenance; Electrical Configuration - Schroff CPCI PICMG 2.16 Benutzerinformation

2.2 Assembly

The subrack can be equipped with 6 U/ 4 F CPCI PICMG 2.16
boards on the front and 6 U/ 4 F boards with rear I/O on the back.
Boards are mounted in guide rails and fixed with collar screws.
The guide rails from the system slot are red. The blue guide rails
characterize the Fabric slots. Up to four 3 U CPCI power supplies
can be integrated using the green guide rails.
For an optimal heat dissipation, unused 6 U slots must be closed
with air flow barrier front panels, unused power supply slots with
front panels.
The subrack can be mount on the cabinet's upright using the eight
delivered screws.

2.3 Starting-up the system

The mains/line fuse value must be adjust to the real current
consumption of the complete system. Connect the system to the
mains/line and switch it on by using the mains/line switch. Green
LEDs on the power supplies indicate that the voltages exist. Red
LEDs indicate a damage.

2.4 Maintenance

In order to remove the fan modules, loos the collar screws and
hinged the front panel (Position 6, chapter Mechanical construc-
tion). A faulty fan can be replace while the system is operating.
The air filter is accessible underneath the fan tray. The filtre must
be change regurlarly, depending on the environmental conditions.
CPCI PICMG 2.16 10 U
3

Electrical configuration

3.1 Cabling, general

1.5
10002500