Schroff CPCI PICMG 2.16 Benutzerinformation Seite 11

Contents
Contents English, page .............................................. 1.2
1 Introduction ............................................................... 1.2
1.1 Please read immediately! ............................................ 1.2
1.2 Description .................................................................. 1.3
1.3 Safety instructions ....................................................... 1.3
1.4 Advice .......................................................................... 1.3
2 System overview ........................................................ 1.4
2.1 Mechanical configuration ............................................. 1.4
2.2 Assembly ..................................................................... 1.5
2.3 Starting-up the system ................................................. 1.5
2.4 Maintenance ................................................................ 1.5
3 Electrical configuration ............................................. 1.5
3.1 Cabling, general ........................................................... 1.5
3.2 Fan Control Module (FCM) .......................................... 1.6
4 Technical data ............................................................ 1.7
4.1 Mechanical data .......................................................... 1.7
4.2 Electrical data .............................................................. 1.7
4.2.1 Power supply ............................................................... 1.7
4.2.2 Fan Control Module (FCM) .......................................... 1.8
4.2.3 Fan .............................................................................. 1.8
4.2.4 Backplane .................................................................... 1.8
4.3 General data ................................................................ 1.8
4.4 Shielding attenuation curve europacPRO .................... 1.9
4.4.1 Mesuring principle ....................................................... 1.9
4.4.2 Results ......................................................................... 1.9
5 Error correction ......................................................... 1.10
6 Replacement parts .................................................... 1.10
7 Warranty conditions .................................................. 1.10
CPCI PICMG 2.16 10 U
1 Introduction
1.1 Please read immediately!
This microcomputer packaging system is not a complete unit
Seite which can be delivered directly to the end user; other items need to
be fitted. Before deliverying the complete unit, the following checks
must be carried out according to the specifications:
does the assembled unit comply with the safety instructions
currently applicable in the country in which it is going to be
used?
are all the apertures of the case closed so that the user cannot
get into the case (finger test)?
Make sure that
all safety checks have been carried out on every unit,
the operator knows what safety measures have to be
undertaken (e.g. GND/earthing),
the overall unit complies with all other specifications at the
place of use and in the country in which it is going to be used,
e.g. interference limits, approval by the telecommunications
authorities.
The above assumes that the initial testing, completion and
final testing of the units have been carried out or at least
supervised by qualified technicians. These instructions are
directed exclusively to these qualified technicians.
Check the packing material. At least the following should be inclu-
ded:
1 bag of assembly parts for mounting the system subrack into
a case or cabinet
When the unit has been unpacked the safety and function
checks should be carried out immediately, see section
"Introduction - Safety instructions". No liability is accepted
for boards which have been destroyed by faulty operating
voltages!
If there are problems please contact your supplier or your local
Schroff representative, see back cover of this booklet.
1.2