Conformity Declaration - Metabo SE 4000 Originalbetriebsanleitung

en ENGLISH
Original instructions

1. Conformity Declaration

We, being solely responsible, hereby declare that
these screwdrivers conform to the standards and
directives specified on page 3.
2. Specified Use
The machine is designed for inserting and removing
screws in/from wood, gypsum plasterboards on
metal profile rails or timbers, plastics and similar
materials.
The machine is not suitable for inserting and
removing screws in metal materials.
The user bears sole responsibility for damage
caused by improper use.
Generally accepted accident prevention
regulations and the enclosed safety information
must be observed.
3. General Safety Instructions
For your own protection and for the
protection of your electrical tool, pay
attention to all parts of the text that are
marked with this symbol!
WARNING – Reading the operating instruc-
tions will reduce the risk of injury.
WARNING Read all safety warnings and
instructions. Failure to follow all safety warn-
ings and instructions may result in electric shock,
fire and/or serious injury.
Keep all safety instructions and information for
future reference.
Pass on your electrical tool only together with these
documents.
4. Special Safety Instructions
Pull the plug out of the plug socket before any
adjustments or servicing are performed.
Take care to avoid gas, electricity, and water
supplies!
Hold the power tool only at insulated housing parts
if there is any danger of making contact with
concealed electric cables or the supply cable.
Contact with live wires energises the metal parts of
the housing and can cause electric shock to the
operator.
Wear ear protectors when working for long periods
of time. High noise levels over a prolonged period of
time may affect your hearing.
Note that high counter-torques are possible during
work. Always hold the tool firmly, ensure you have
good footing and concentrate when working.
Do not keep the ventilation slots closed.
8
Materials that generate dusts or vapours that may
be harmful to health (e.g. asbestos) must not be
processed.
5. Overview
See page 2.
1 Rotation selector switch
2 Trigger
3 Locking button (continuous activation)
4 Scaffold hook mounting
5 Scaffold hook *
6 Depth stop
7 Tool *
8 Quick-release lock
9 Stop sleeve
* depending on equipment/not in scope of delivery
a 6. Commissioning
Before plugging in, check to see that the rated
mains voltage and mains frequency,
as stated on the rating label, match your power
supply.
Scaffold hook (5) assembly: Clip into scaffold
hood mounting (4) and turn until it engages in the
desired position.
7. Use
7.1 Switching On and Off
To start the machine, press the trigger switch (2).
The speed can be changed at the trigger switch by
pressing.
For continuous operation the trigger switch can be
locked using the lock button (3). To stop the
machine, press the trigger switch again.
7.2 Selection of direction of rotation
Do not activate the rotation selector
switch (1) unless the motor has
completely stopped.
Select direction of rotation:
R = Clockwise
L = Counter-clockwise
7.3 Tool change
Inserting tool:
Hold the quick-change lock (8) firmly in position and
insert tool.
Check that the quick-change lock (8) is in its front
position. Pull on the tool. The tool must be held
securely in position by the quick-change lock (8).
Removing the tool:
(See page 2, illustration 1a)
- Remove depth stop (6).