Bluetooth ® Pairing - Hama SOUNDCHEST Bedienungsanleitung

• Charge the speaker fully before using it for the first
time.
• Connect the included Micro-USB charging cable to
the speaker's Micro-USB port (3).
• Connect the unused connector on the Micro-USB
charging cable to a suitable USB charger. Please refer
to the operating instructions for the USB charger
used.
Note – Charging
• It takes approx. 4 – 5 hours to completely charge
the product.
• The speaker's battery can be charged whether the
speaker is on or off.
• If the battery capacity is less than 10%, the
speaker will emit two acoustic signals. You will
only receive this information if the speaker is on.
• The actual battery life varies depending on use of
the device, the settings and the ambient conditions
(rechargeable batteries have a limited service life).
4.3 Audio playback via the included audio cable
(3.5 mm jack)
• Ensure that the speaker is switched off.
• Connect your mobile terminal device (MP3 player,
smartphone, etc.) and the AUX input (2) of the
speaker using the included 3.5 mm audio cable.
• Set the volume on your terminal device to a low level.
• Switch on the speakers as described in 4.1,
Switching the product on and off. The status LED
(4) is now green.
• Start and control audio playback on the connected
terminal device accordingly.
• Turn the rotary control to the left or right to increase
or decrease the volume.
• Press the function button
Note
Please note that you cannot establish the Bluetooth
connection described under 4.4 and 4.5 if an audio
cable is connected.
(1) to mute the speaker.
®
4.4 Bluetooth pairing
®
Note
• Check whether your mobile device (MP3 player,
mobile phone, etc.) is Bluetooth
• If not, you can only use the speaker for playback
using the included audio cable.
• Note that the maximum range for Bluetooth
10 metres without obstacles such as walls, people,
etc.
• Make sure that your Bluetooth
device is on and Bluetooth
• Make sure that the speaker is located within the
Bluetooth
range of max. 10 metres.
®
• Switch on the speakers as described in 4.1
Switching the product on and off.
• The status LED (4) starts to flash in blue. The speaker
searches for a connection.
• Open the Bluetooth
®
and wait until Hama Soundchest appears in the list
of Bluetooth devices found.
®
• Select Hama Soundchest and wait until the speaker
is listed as connected in the Bluetooth
your terminal device. An acoustic signal confirms that
connection was successful.
• The status LED (4) now remains blue.
Note – Bluetooth
• Some terminal devices require a password in order
to connect to another Bluetooth
• If your terminal device requests a password for
connection to the speaker, enter 0000.
Note
• The speaker always stores the last eight terminal
devices paired.
• The speaker will automatically connect to the last
terminal device paired when it is switched on the
next time.
capable.
®
capable terminal
®
is activated.
®
settings on your terminal device
settings on
®
password
®
device.
®
is
®
3