Werbung
Verfügbare Sprachen
Verfügbare Sprachen
apply to adaptations or other
alterations.
de sig ned solely for private use.
The batteries must never be
charged. Do not throw the bat-
teries into a fire. Do not expose
the batteries to excessive heat.
Do not short-circuit the batte-
ries. Risk of explosion!
Commissioning
1 Disassemble the mechanical
thermostat by turning it to
the left as far as it will go. Un-
screw the union nut until you
can remove it from the
thread.
2 Open the battery compart-
ment and write down the se-
rial number before inserting
the batteries.
3 Wait until the pin is fully re-
tracted and "A1" appears on
the display. When the pin is
fully retracted "A2" appears
on the display.
4 Now install the radiator ther-
mostat. It fits all standard
valves with an M30 x 1.5 mm
connection thread. You will
need adapters for some hea-
ter valves. Adapters for Dan-
foss valves in the RAV, RA
and RAVL series are inclu-
ded.
The
device
5 Briefly press the button on
is
the radiator thermostat to
start
process. 'A3' will appear on
the display. This procedure
can take up to three minutes.
If the procedure is aborted,
'F2' will appear on the dis-
play. You can restart the pro-
cedure by pressing the but-
ton again.
6 Integrate the device via the
search mode of the user soft-
ware in the SmartHome.
7
the
self-adjustment
EN
Werbung
