Safety Instructions - Casada Quattromed III Bedienungsanleitung

Safety Instructions

Please carefully read the following instructions before using this massage device to ensure its
proper function and optimal effect. Please retain these instructions for use!
This massage device complies with the recognised principles of technology and current safety regulations.
•
This equipment is maintenance free. Any necessary repairs must be performed by an authorised profes-
•
sional. Improper use and unauthorised repairs are prohibited for safety reasons and will void the warranty.
Never touch the power plug with wet hands.
•
Please avoid the equipment coming into contact with water, high temperatures and direct sunlight.
•
Be sure to unplug the equipment from the power point during extended periods of non-use to eliminate
•
the risk of a short circuit.
Do not use damaged plugs, cords or loose sockets. Damaged plug or cords must be replaced by the manu-
•
facturer, service representative or qualified personnel. In the event of malfunction unplug the equipment
immediately. We assume no liability for damages resulting from wrongful or improper use.
In order to prevent excessive stress on muscles and nerves, the recommended massage time of 30 minutes
•
should not be exceeded.
Never use pointy or sharp objects.
•
Any massage – also massage by hand – has to be avoided during pregnancy and/or in case of one or more
•
complaints in the area of the massage: recent injuries, thrombotic illnesses, inflammations and swelling of
any kind as well as cancer. Consultation of your physician is recommended prior to any treatment of af-
flictions and ailments.
Do not use the device while driving.
•
If you depend on electrical aids such as a pacemaker, please consult your physician prior to usage in any case.
•
Start Up
Carefully loosen the screw on the back of the massage device. Remove the cover and connect
the plug to the adapter. Attention! The screw is not to be used again. Just remove it.
Please connect the adapter with the device and subsequently plug the power plug into the
power socket. Now turn on the device by the remote control.
12
Equipment / Functions
In the new Quattromed III Limited Edition the massage heads normally made from plastic are substituted
with heads of jade. The natural powers of jade are increased by an integrated carbon heating system. The
massage will be intensified by sending healing warmth into the depths of the muscles.
The heat is permeating through the stone slowly and is only noticeable after a few minutes. During this
heating phase the tissue is already being relaxed by the rotating movement of the massage heads and
surface hardening and tensions are being released. The optional vibration also allows for the stimulation
of the circulation and lymphatic system. Blood circulation is effectively improved and the purification fa-
cilitated.
Please position the Quattromed III Limited Edition on a stable chair. The burden of your bodyweight
intensifies the massage effect. Please ensure that your whole body is positioned centrally so that the
massage heads run parallel to your spine. Using the rolling function you can vary the width between the
massage heads, pressing the according button.
The massage function will switch off automatically after 15 minutes. In order to increase the lifespan of
the motors, please switch on the massage heads again only after a minimum of 30 minutes have passed.
This gives the motors time to cool down again. You should also allow a period of rest for your body. We
recommend conducting the massages only two, maximum three times a day in order to not overstress
your muscles.
For your own safety we equip the machines with a protection against overheating. Heat is
created in the motors when placed under great stress and excessive pressure. Before this
could create any risk, the machines will switch off automatically and will only allow switching
on again after an appropriate downtime between 30 and 40 minutes.
Troubleshooting
Error Adjustment
The massage device cannot oper- Check the connection of the adapter.
•
ate even though it has been con-
nected to the power supply. The device could be overheated after prolonged use. It
•
will automatically cool down to resume its normal con-
dition. Please turn off the power and allow the device to
cool off for 30 to 50 minutes.
13