Mounting; Required Tools; Mounting The Ges9-3 Plastic Service Unit; Removing The Hinged Lid For Mounting - OBO Bettermann GES9-3B Montageanleitung

The pressure plate is made of hot-galvanised sheet steel.
The depth of the floor covering recess in the hinged lid is 5 mm and can, if
necessary, be extended to 10 mm by reducing the spacer frame.
The service unit should also be used in connection with the GB mounting box
of MT module support for the installation of Modul 45 or standard devices. The
MTU support system can be used for the installation of data technology modu-
les of different manufacturers. The number of installable installation devices
depends on the type of installation devices.
4

Mounting

Note: When carrying out mounting work on the hinged lid, if not otherwise
specified, diagrams of the hinged lid with handle clamp are used as an
example.
4.1

Required tools

– Battery-operated screwdriver or
– screwdriver
4.2

Mounting the GES9-3 plastic service unit

When delivered, the GES9-3 plastic service unit is already mounted.

4.2.1 Removing the hinged lid for mounting

Note: The hinged lid covers two of the four screws of the universal fastening
bracket and must be removed to mount the carpet protection frame.
• Opening the hinged lid with handle clamp:
– Open the hinged lid with handle clamp and lift it out (see Fig.
• Opening the hinged lid with locking slider:
1. Actuate both locking sliders (see Fig.
2. The hinged lid springs open.
3. Lift the hinged lid by the cord outlet.
• Turn out both hinged lids from the carpet protection frame by turning them
to the left and remove them (see Fig.

4.2.2 Changing the clamping area of the universal fastening bracket

The default clamping range of the universal fastening bracket is 7 to 45 mm
and can, if necessary, be changed to 37 to 65 mm.
GES9-3 plastic service unit
, )
1
).
Mounting
, ).
1
EN | 19