Installation; Power Supply; Installing The Camera; Setting The Angle Of View On The Camera - Abus TVIP62000 Bedienungsanleitung

3. Installation

Make sure that all accessories and parts listed above are present in the scope of delivery. An Ethernet cable
is required for camera operation. This Ethernet cable must meet UTP Category 5 (CAT 5) specifications and
must not be longer than 100 metres.

3.1 Power supply

Before starting installation, ensure that the mains voltage and the rated voltage on the supplied power supply
unit are identical.
3 – Power supply, 12 VDC,
5.5 x 2.1 mm circular connector
4 – Network connection, RJ45

3.2 Installing the camera

Position the camera in a suitable location and
use the screws and wall plugs provided to
fasten it in place.
IMPORTANT!
The camera must be disconnected from the mains power during installation.

3.3 Setting the angle of view on the camera

To align the camera, loosen the corresponding fixing screw with the hexagon socket key provided.
Ensure that the screws are tightened again after setting the desired camera position.
3
4
48