Comfort Set-Point Maximum Value; Set-Point Reduction Value In Eco Mode; Freeze Protection Set-Point Value; Temperature Measurement Correction By The Used (Offset Adjustment) - Fondital MANIVA __ Installations-, Betriebs- Und Instandhaltungsanleitung

Once this mode is accessed, the thermostat displays the following parameters:

4.5.1 COMFORT SET-POINT MAXIMUM VALUE.

The indication of this selection is displayed by selecting digit "1" present on display left side (vertical scale from 1 to 7) and by the value of
the maximum set-point of the comfort mode and by the sun pictogram.
Modification possible from 22°c to 30°C in steps of 0.5°C. Default value: 28°C.
These modifications are made through the "+" key to increase, and through the "-" key to decrease. A
short press on "OK" will confirm and store the adjustment.

4.5.2 SET-POINT REDUCTION VALUE IN ECO MODE.

The indication of this selection is displayed by selecting digit "2" present on display left side (vertical scale from 1 to 7) and by the reduction
value compared to the comfort set-point in tenths of degree and by the moon pictogram.
Modification possible from 0 to 10°C in steps of 0.5°C, or 3 dashes on the display.
The reduction default value is 3.5°C. These modifications can be set through the "+" key to increase and
through the "-" key to decrease.
A short press on "OK" will confirm and store the adjustment.
If the three dashes on the display are selected, the eco set-point will no longer be associated to the
comfort set-point, thus derogating from the limits specified in paragraph 4.1.2.

4.5.3 FREEZE PROTECTION SET-POINT VALUE

The indication of this selection is displayed by selecting digit "3" present on display left side (vertical scale from 1 to 7) and by the value of
the comfort mode set-point and by the snowflake pictogram.
Modification possible from 7°C to 14°C in steps of 0.5°C. Default value: 7°C.
These modifications can be set through the "+" key to increase and through the "-" key to decrease. A
short press on "OK" will confirm and store the adjustment.

4.5.4 TEMPERATURE MEASUREMENT CORRECTION BY THE USED (OFFSET ADJUSTMENT).

The indication of this selection, allowing to correct a constant value on the whole range of the measured temperature, is displayed by
selecting digit "4" present on display left side and by the correction value in tenths of degree
It allows correcting any temperature reading difference between the radiator and a thermometer positioned in a different point of the room.
Be reminded that the radiator detects the temperature in its installation area and in room lower part.
Modification possible of +/- 5°C in steps of 0.1°C. Default value: 0°C.
These modifications can be set through the "+" key to increase and through the "-" key to decrease.
A short press on "OK" will confirm and store the adjustment.
The picture shows an example for a correction of – 1.5°C.

4.5.5. WINDOW DETECTION

The indication of this selection, allowing to activate or deactivate the open window detection function, is displayed by selecting digit "5"
present on display left side (vertical scale from 1 to 7). Default setting: window detection not active.
Function is activated and deactivated by pressing repeatedly key "+".
When the function is active the window pictogram is lit on the display
A short press on "OK" will confirm and store the adjustment.
EN-30
.