Product Set Up - Nuna IVVI-SERIES Bedienungsanleitung

Product Set Up

Carry Cot assemble
1
- Open the wire support on both side of the carry cot. (1)
Then click the wire into the four plastic parts. A "Click"
sound means the wire support is secure.(1)-1 Place the
mattress into the carry cot, (2) and smooth it down.(3)
Always use the mattress when using the carry cot.
Mattress cover can easily be removed to wash.
2
- Attach the pocket to the carry cot with zipper. (4)
3
- Attach the boot to the carry cot with the zippers on
either side. (5)
Adjust Carry Cot hood
1
- Pull hood towards front end to secure. (6)
2
- Close the hood by pressing the folding buttons on either
side. (6)-1
Attach Carry Cot onto Chassis
1
- Align the sides of the carry cot with the adapters on the
frame.
2
- Place the carry cot directly down until it clicks into
place. (7)
3
- A click sound means carry cot assembled completely.
Always remove the car seat adapters before using the
carry cot.
Please don't fold stroller when carry cot is attached.
8 IVVI series carry cot instructions
Canopy Features
1
- Fold the rear panel of the carry cot canopy upwards for
more ventilation. (8)
2
- Pull the canopy flap out from under the carry cot
canopy, then secure it to the two sides of carry cot with
magnets. (9, 10)
Remove Carry Cot
1
- Press release buttons on both sides of carry cot and
then lift it upwards. (11)
Use Rain Cover
1
- To assemble the carry cot rain cover, place it over
the carry cot, and attach the 2 pairs of hook and loop
fasteners on the front of rain cover. (12)
Please always check ventilation, especially in hot
weather when the rain cover is on the product.
Please check that the rain cover has been cleaned and
dried before folding.
IVVI series carry cot instructions 9